Title
Investigation of GaN-on-GaN vertical p-n diode with regrown p-GaN by metalorganic chemical vapor deposition
Date Issued
03 December 2018
Access level
open access
Resource Type
journal article
Author(s)
Fu K.
Fu H.
Liu H.
Alugubelli S.
Yang T.
Huang X.
Chen H.
Baranowski I.
Montes J.
Zhao Y.
Publisher(s)
American Institute of Physics Inc.
Abstract
To mimic selective-area doping, p-GaN was regrown on an etched GaN surface on GaN substrates by metalorganic chemical vapor deposition. Vertical GaN-on-GaN p-n diodes were fabricated to investigate the effects of the etch-then-regrowth process on device performance. The crystal quality of the sample after each epitaxial step was characterized by X-ray diffraction, where the etch-then-regrowth process led to a very slight increase in edge dislocations. A regrowth interfacial layer was clearly shown by transmission electron microscopy. Strong electroluminescence was observed with three emission peaks at 2.2 eV, 2.8 eV, and 3.0 eV. The forward current density increased slightly with increasing temperature, while the reverse current density was almost temperature independent indicating tunneling as the reverse transport mechanism. This result is very similar to the reported Zener tunnel diode comprising a high doping profile at the junction interface. High levels of silicon and oxygen concentrations were observed at the regrowth interface with a distribution width of ∼100 nm. This work provides valuable information on p-GaN regrowth and regrown GaN p-n diodes, which can serve as an important reference for developing selective doping for advanced GaN power electronics for high voltage and high power applications.
Volume
113
Issue
23
Language
English
OCDE Knowledge area
Química física
Scopus EID
2-s2.0-85057750041
Source
Applied Physics Letters
ISSN of the container
00036951
Sponsor(s)
This work was supported by the ARPA-E PNDIODES Program monitored by Dr. Isik Kizilyalli and partially supported by the NASA HOTTech Program grant number 80NSSC17K0768. We acknowledge the use of facilities within the Eyring Materials Center at Arizona State University. The device fabrication was performed at the Center for Solid State Electronics Research at Arizona State University. Access to the NanoFab was supported, in part, by NSF Contract No. ECCS-1542160.
Sources of information:
Directorio de Producción Científica
Scopus